Mercury outboard parts warehouse

Mercury crankshaft roller bearings
Mercury outboard parts warehouse Home Page
3.0L, 200 DFI, 225 / 250 EFI parts / drawing
3.9, 4, 4.5, 6, 7.5, 9.8 hp. drawing
6-8-9.9-10-15 hp. parts / drawing
4 Stroke Verado inline 6 lower unit parts layout
18XD, 20 and 25 hp. drawing
30 hp. 2 cylinder 40-50 hp. 2 & 3 cylinder parts
30 hp. to 125 hp. components
35 to 70 hp. 2 / 3 / 4 cylinder components
50 / 55 / 60 hp. components & 40, 50 and 60 hp EFI 4 cylinder lower units
65 hp. thru 225 hp. lower unit parts
Anodes lower unit
Bearings (powerhead) (center)
Bearings (roller) (crankshaft)
Bearings (ball) (crankshaft)
Carburetor diaphragm and gasket kits
Carburetor inlet needles & seats
Contact T.C. Electronics / Marine
Crankshaft bearing & oil seal application
O-rings (crankshaft)
Fuel pump kits
Fishing Links Add Your URL
Fuel Filter Kits
Gear sets / Clutch Dog
Gears set application chart
Lower gearcase gear chart 115 thru 250 hp.
Head gaskets
Impeller 6hp. 8hp. 9.9hp. XR10hp. 10hp. and 15 hp.
Impeller 30, 35, 40, 45, 50, 60 and 70 hp.
Impeller 115 thru 200hp. & 225hp. with 2.4 litre engine
Impeller 4 thru 9.8 hp.
Seloc outboard repair manuals 2-stroke engine
Prop kits and hardware applications
Power head gasket kit applications
Mercury powerhead gasket kits
Piston & rings application chart
Oil seals (powerhead)
Mariner/Mercury outboard parts tech help drawings
Seal kits
Piston kits
Propeller or prop shafts
Water Pump Kits
Impeller
Water pump application chart 2 stroke (3.5hp - 9.9hp)
Water pump kit application chart (10 - 50hp)
Water pump kit application chart (50 - 70 hp)
Water pump kit application chart (75 - 100 hp)
Water pump kit application chart (105 hp and up)
Water pump application chart 4 stroke
OMC Stern Drive Parts Warehouse
Tools
Mercury outboard used parts
Powerhead gasket set 35-40 hp.
Rectifier
Ignition coil
Relay (power trim)
Solenoids (power trim)
Solenoids (starter)
Drive shaft (upper)
Points condenser and tune up kits
Thermostat kit
Thermostat V135 thru V200
Thermostat poppet valve kits
Propeller wrench and prop puller
Prop hardware kits
Force prop nut kit

GLM Marine aftermarket Mercury crankshaft roller bearings for 10 hp. thru 300 hp. with V6 3.4 liter powerhead

  • Powerhead center bearing and crankshaft roller bearing are listed below with OEM numbers
  • Note some roller bearings are split type bearing for power head

Crankshaft bearing photo
Roller bearing descripton
 

# 16510 roller bearing $ 32.98
OEM # 31-43013T3
 

# 16500 roller bearing $ 34.98
OEM # 31-16756A4
 

# 16520 roller bearing $ 28.98
OEM # 31-74248T
 

# 16530 roller bearing $ 133.98
OEM # 31-816773A1
 

# 16540 roller bearing $ 91.98
OEM # 31-43013T93496T

Crankshaft roller bearing tech support line # 416 751-7326

omcparts@rogers.com

Money Orders Credit Cards PayPal USA Bank Transfer