OMC 800/Cobra parts *Outdrive drawings *How to videos

T.C. Electronics/Marine (416) 751-7326 Home Page

Electric shift outdrive repair help *Page 2

Stringer lower gearcase electric shift
swivel housing repairs

  • Part two instructions

Exploded View Drawings
Search by part number or description here

M Remove gasket material
M Remove gasket material

Remove-gasket-material.

 

N Sandblast or wire brush all oil seal areas and gasket surface
N Sandblast or wire brush all oil seal areas and gasket surface

Sandblast-or-wire-brush-all-oil-seal-areas-and gasket-surface

O Drive shaft scoring in old seal area
O Drive shaft scoring in old seal area

Drive-shaft scoring in old seal area will require new seals to be installed offset by 1/8 inch. seal can be placed up or down from original position

P Loctite 680 will be required to hold seal in housing
P Loctite 680 will be required to hold seal in housing

Loctite 680 will be required to hold seal in housing

Q 87620 GLM aftermarket seal kit OEM 981797
Q 87620 GLM aftermarket seal kit OEM 981797

87620 GLM Marine aftermarket seal kit OEM 981797

R Apply 680 Loctite to retainer seal area
R Apply 680 Loctite to retainer seal area

Apply 680 Loctite to retainer seal area

R2 Apply 680 Loctite to each seal to be installed
R2 Apply 680 Loctite to each seal to be installed

Apply 680 Loctite to each seal to be installed in swivel housing

S Install the 1st seal face down or spring area down
S Install the 1st seal face down or spring area down

Install the 1st seal face down or spring area down

Installed offset seal
Installed offset seal

Insert-2nd seal with Loctite facing up or back to back

U Install 2nd seal 1-8 inch offset from retainer area
U Install 2nd seal 1-8 inch offset from retainer area

Install 2nd seal 1/8 inch offset from retainer area with loctite holding half of seal. Note loctite holds over 1200 lbs per square inch with less than .010 gap in materials.

Installed offset seal
Installed offset seal

Installed offset oil seal 1/8 inch from casting material