OMC parts 800 / Cobra outdrive drawings * How to videos

T.C. Electronics/Marine (416) 751-7326 Home Page

OMC electric shift outdrive repair *How to steps 13 to 24

OMC Stringer lower gearcase electric shift clutch spring, forward and reverse coil repairs pictures 13 to 24

  • Note: (Warning) swivel housing work must be preformed before continuing or reverse coil wires will be damaged
  • Note: Clutch spring and forward gear assembly pictures shows how to remove parts

Search by part number or description here

13 Pull shaft upward by hand
13 Pull shaft upward by hand

Pull shaft upward by hand

 

14
14

Remove clutch coil assembly and shaft

15 See repair note 3 to rebuild reverse unit
15 See repair note 3 to rebuild reverse unit

See repair note 3 to rebuild reverse unit

16 Will require  1 1/16 inch open end wrench
16 Will require 1 1/16 inch open end wrench

Will require 1 1/16 inch open end wrench 

17
17

Hold nut from turning do not allow wrench to damage seal area

18
18

Can tape end off wrench or place rag around the tool

19
19

Drive shaft adapter made from old upper water pump shaft and nut with dowel pin

20
20

Turn drive shaft adapter counter clock wise

21 Remove nut
21 Remove nut

Remove nut

 

22
22

Use pry bar to move drive shaft forward and bearings outside race 1 inch

 

23
23

Pry bar must be able to push upper race out.

 

24
24

Remove all four bearing parts and shim together

24B Pinion can be now taken out by hand
24B Pinion can be now taken out by hand

Pinion bearing can be now taken out by hand

24C
24C

With pinion gear removed bearing pins will fall into outdrive see picture 35